In order to obtain a higher degree of vacuum for the vacuum clay mixer, in addition to ensuring that the vacuum system is well sealed and airtight, within a certain range, it also depends on whether the operation and use of the DVE vacuum pump and the vacuum clay mixer are standardized. The most important thing is to To ensure the continuous operation of the DVE vacuum pump, the key is to do a good job of cooling down the DVE vacuum pump.

Because the vacuum mud mixer is to obtain a higher degree of vacuum, the amount of gas flowing through the DVE vacuum pump will inevitably be reduced, and the large amount of heat generated in the pump cavity of the DVE vacuum pump must be absorbed by the pump body and dissipated to the outside atmosphere. Taking cooling measures or improper cooling measures can not balance the heat and dissipate it to the outside atmosphere, which will cause the temperature of the DVE vacuum pump to rise sharply and be forced to stop.

Therefore, in order to ensure a higher vacuum degree of the vacuum mud mixer, the following start-up and stop sequence should be followed when working. When starting up, the DVE vacuum pump cooling water should be connected first before the DVE vacuum pump drive motor can be started, and finally the vacuum can be started. The drive motor of the clay drill.
www.dvevacuum.com